Just Another RepRap

I got the RepStrap back again today, and tonight I was able to print 9 new pieces (6 unique types). Here are 8 (5 types) of them:

Left: y-idler-bracket_1off, Top: xlr-bracket_1off, Bottom: circuit-board-spacer-m4_2off, TopRight: y-bar-clamp_10off, Right: drive-pulley_3off

(the one at the bottom is a little grey because we’d been printing with black ABS before this and it took a while to clear out).

I decided it was time to bolt the acryllic down to the wood base (previously it was just double-side taped).

The 9th piece is printing now while I should be sleeping. I can see it on my iPhone because I set up my Rovio on the desk to point at the print bed up close. The screenshot is rotated, but here’s a screenshot of the piece that’s currently printing:

You can see the right corner curling up now. Man I really need to make a heated bed. Why is it always that same corner I wonder?

Jeff sleep now.

[Update: Unattended Print Fail (again): (IPhone screenshot of Rovio – low res)

I guess the other corner finally came up too! A heated bed can’t come soon enough.. I need some aluminum…

This entry was posted on Friday, December 18th, 2009 at 3:03 am and is filed under MyRepRap. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.